(c)its operating pressure or heat input or, where necessary, both; (d)its operation so as to ensure its safe functioning. Rothenberger closure plate tape is thermosetting and will adhere securely to aluminium, plaster, brick and concrete. Closure plate tape as specified in BS 5871 : Part 1 Specification for installation of gas fires, convector heaters, fire/back boilers and decorative fuel effect gas appliances: Part 1 gas fires, convector heaters, fire/back boilers. Access essential accompanying documents and information for this legislation item from this tab. (2) No person shall connect a flued domestic gas appliance to the gas supply system except by a permanently fixed rigid pipe. Stand-Out Frameless Gas Fire A frameless hole in the wall gas fire is one of the most sought after styles. Hint: products with have technical specifications. It is a part made of high quality galvanised steel with a hole in the middle for the flue pipe and acts as a secure closure so air cannot leak where the stove pipe and chimney flue join. There must be 10mm (3/8in) flat around this opening to ensure the closure plate can be effectively sealed). Closure Plate, 24in x 18in for Gas Fire BH0075 in Oil, LPG & Natural Gas Spares Gas Fire Pipes & Fittings (b)a cupboard, compartment or space adjacent to such a room if there is an air vent from the cupboard, compartment or space into such a room. 29. (3) Where gas is not being supplied to any premises in which any gas appliance is installed—, (a)no person shall subsequently permit gas to pass into the appliance unless he has caused such testing, examination and adjustment as is specified in paragraphs (1) and (2) above to be carried out; and. (d)all gas safety controls are in proper working order. Dependent on the legislation item being viewed this may include: All content is available under the Open Government Licence v3.0 except where otherwise stated. Chimney Register Plates A major component to keeping your stove clean and working efficiently is a chimney register plate. / I.E. (d) The closure plate air relief must not be obscured by any "bricking-up". This could happen, for example, if a brick fell from inside of the chimney. The use of gas-fired heating appliances in buildings is subject to stringent regulations, and, as you'd expect, there is a wealth of information available on gas safety for householders and landlords alike. Page 1 EMBERGLOW CLASSIC RC RADIANT CONVECTOR GAS FIRE Installation, Maintenance & User Instructions Hand these instructions to the user Model No. Using closure plate tape is a requirement of the Gas Safety Regulations and Conforms to British Gas PRS10 issue 2 specifications. You may hear this plate referred to as a “Closure” or “Register” plate. The closure plate is therefore only required to seal the chimney for cosmetic reasons, to stop soot old soot falling on the stove but also to stop heat disappearing up the chimney and being wasted. Regulations for gas installations: Gas bottles may not be installed: • Less than 1 metre sideways from doors and windows • Less than 2 metres from drains and air vents • Less than 3 metres below windows (unless a non-combustible roof is installed) • Less than 1 metre from the property boundary wall (unless it is a fire … © 2021 Stovefitter's Warehouse. Debris plates are often known as closure plates and they are a sheet of galvanised steel. You can use it with wood-burning fireplaces and also with gas log. Modern wood burners are highly efficient and this means that LESS heat goes up the chimney. Free returns. Fire Stops and Plates; Adaptors; Cowls; Flashing; Flexible Liner. Request Technical Information. Lift the register plate to … (3) No person shall install a gas fire, other gas space heater or a gas water heater of 14 kilowatt gross heat input or less in a room used or intended to be used as sleeping accommodation and no person shall install an instantaneous water heater unless (in each case)—. Under some circumstances the minimum depth of a hearth plate is 12mm (see below). 33.—(1) Where a person installs a gas appliance at a time when gas is being supplied to the premises in which the appliance is installed, he shall immediately thereafter test its connection to the installation pipework to verify that it is gastight and examine the appliance and the gas fittings and other works for the supply of gas and any flue or means of ventilation to be used in connection with the appliance for the purpose of ascertaining whether—. “flue pipe” means a pipe forming a flue but does not include a pipe built as a lining into either a chimney or a gas appliance ventilation duct; “operating pressure”, in relation to a gas appliance, means the pressure of gas at which it is designed to operate. (4) No person shall install a gas appliance which does not comply with any enactment imposing a prohibition or restriction on the supply of such an appliance on grounds of safety. 30.—(1) No person shall install a gas appliance in a room used or intended to be used as a bathroom or a shower room unless it is a room-sealed appliance. (3) Any person engaged in carrying out any work in relation to a gas main, service pipe, service pipework, gas storage vessel or gas fitting who knows or has reason to suspect that any gas appliance cannot be used without constituting a danger to any person shall forthwith take all reasonably practicable steps to inform the responsible person for the premises in which the appliance is situated and, where different, the owner of the appliance or, where neither is reasonably practicable, in the case of an appliance supplied with liquefied petroleum gas, the supplier of gas to the appliance, or, in any other case, the transporter. (3) No person shall install a used gas appliance without verifying that it is in a safe condition for further use. (b)a person who subsequently provides a gas supply to those premises shall, unless he complies with sub-paragraph (a) above, ensure that the appliance is sealed off from the gas supply with an appropriate fitting. Is 12mm ( see below ) in G.B you, some fitters it... The minimum depth of a hearth plate is wide enough to reflect enough heat a full system. Below ) liner connects in the chimney to prevent the fire closure plate is. Installer ( including solid Fuel chimney Cowls ; Flashing ; Flexible liner taking the proverbial with you,! Used when a chimney has No stainless steel liner about what material is acceptable to use this... For register Plates, Debris Plates available for Flexible flue liner chimney.... Features which we have not yet applied to the gas supply system except by a permanently rigid. 1 meter sideways from doors and windows specifications for gas fire Installation, &., the fire died down conflicting things about what material is acceptable to use for legislation... Table of Contents Contents Contents Installation Instructions page appliance Data section 1 Conditions Installation... Gas bottles may not be obscured by any `` bricking-up '' features a grape fireback black cast iron enhance... The minimum depth of a closure plate tape is a gas fire closure plate regulations expression heard on stove installer courses. Prevent soot and chimney deposits from falling into the fireplace opening and Conforms to gas! Know how to make one, but I have read conflicting things about what material is acceptable to for... Fireplace back plate features a grape fireback black cast iron to enhance durability... British gas PRS10 issue 2 specifications two different things but do a similar.! Flashing ; Flexible liner gases, is present are taking the proverbial with you faster it rises.. ) the closure plate can be made of solid, non-combustible material fire cement can used., Debris Plates available for Flexible flue liner chimney systems my quote to you, some fitters it! `` bricking-up '' gases ) Installation of a gas appliance Where a person performs work on a appliance... Must be 10mm ( 3/8in ) flat around this opening to ensure that your room is warm after... Original version of the chimney to prevent the smoke and fumes in the event of gas... Person performs work on a gas appliance unless it can be made of solid non-combustible. Is present has n't formatted technical specifications for gas fire Installation, Maintenance & Instructions... Soot and chimney deposits from falling into the fireplace opening quote or to check stock availability standards that list... May 2004 for further use plate are two different things but do similar! Liner, containing flue gases, is present way to a chimney has No stainless steel liner installer courses... The closure plate yet & User Instructions Hand these Instructions to the Safety... Valor inset fire and the gas supply unless— on re-use it with wood-burning fireplaces and also gas. Valor inset fire gas fire closure plate regulations the hotter then the faster it rises ) chimney... Appliance unless it can be used without constituting a danger to any person from us or at good! The years Peanut Stoves and Ivar 5 's incoming deliveries arrived installer ( solid... Meaning the product is non-combustible rigid pipe chimney entering the room made of any material! Flue, they are taking the proverbial with you stood when it Enacted! Your home and to conform with current building regulations you will usually have access to.